PlantAISim

Deaerator / Droplet Physics

Deaerator Droplet Heat/Mass Transfer

Reference-based what this means

Two separate clocks run on every spray droplet: how fast it heats to saturation (steam-side convection, fast) and how fast dissolved oxygen diffuses out to its surface (inside the droplet itself, much slower). The second one is usually what actually limits deaeration performance.

? New here? How to use this calculator

What this answers: given a droplet size (from your spray nozzle's data, or a typical range if you don't have it yet), how long it takes to heat up, and separately, how long it takes to strip dissolved oxygen down to a target level — which tells you whether a quick spray is enough, or whether the water needs the longer residence time a tray cascade provides.

These are two independent calculations on the same droplet, not one combined number — read both panels below.

The numbers already in the fields are a plausible example, not a template you must match. Overwrite them with your own design's values; the results update as you type.

Unfamiliar term? Look for a ? next to a field label, or browse the full Glossary.

Steam Conditions (deaerator)
barg
m/s — published spray data: ≈1–9 m/s
Droplet?
mm — typical spray range ≈0.1–0.5 mm
°C
Oxygen Stripping Target
ppb
ppb — common design target

Droplet Heating — Whitaker Correlation?

Oxygen Stripping — Diffusion in a Sphere?

What This Means for Vessel Design

Reference-based, two different correlations — and one known gap worth reading. Droplet heating uses Whitaker's correlation (S. Whitaker, AIChE Journal, 1972) for forced convection over a sphere — a standard, widely-validated heat-transfer textbook result, applied here to spray-droplet condensation the same way published deaerator research does (e.g. Effect of droplet diameter on oxygen stripping in deaerators). Oxygen stripping uses the classical transient-diffusion-in-a-sphere solution (Crank, The Mathematics of Diffusion), first-term approximation, assuming a well-mixed external steam atmosphere with negligible surface O₂ concentration. Known gap: Whitaker's correlation describes sensible forced convection; it doesn't separately account for the latent-heat release of direct condensation at the droplet surface. Early experimental work on this exact problem (Brown, 1951) measured droplet condensation heat transfer coefficients around 27,000 W/m²·K for a similar droplet-size range — roughly 50× higher than this module's Whitaker-based estimate typically comes out to. In practice, real droplet heating is likely faster than this calculator suggests, not slower; treat the heating-time result as a conservative upper bound, not a precise prediction. Neither calculation has been checked against a published numeric deaerator example — see Validation & Limitations for the full picture and what's intentionally out of scope (spray-nozzle droplet-formation physics, tray/vessel mechanical sizing).

Quick reaction — was this calculator useful?

Was this calculator useful? Tell us what's missing or what you'd like to see next.

Send Feedback