PlantAISim

Combustion & Emissions / Reference Properties

Flue Gas Thermal Properties

Validated what this means

Cp, density, thermal conductivity, and viscosity for individual flue gas species (CO2, H2O, O2, N2, SO2, plus CO/H2/CH4/Air) and their mixture at any composition and temperature — pure gas properties, no furnace geometry needed.

? New here? How to use this calculator

What this answers: Cp, density, conductivity and viscosity for flue gas species and mixtures, at any composition and temperature — the property engine other modules build on.

The numbers already in the fields are a complete, working example — not a template you must match. Overwrite any of them with your own design's values; the results update as you type.

Unfamiliar term? Look for a ? next to a field label, or browse the full Glossary.

State Point
°C
bar (abs)
Mixture Composition (mole %, wet basis)

Paste values from any combustion module's flue gas output, or enter your own. Auto-normalizes to 100%.

Furnace Geometry (for Mean Beam Length)
m³
m² — total wall+roof+floor
°C — tube wall/membrane surface (≈ saturation temp of water side); bed surface temp for Fixed-bed comes in a later module
Cp: 5-coefficient polynomial per species (verified against a Thai thermodynamics textbook source, already used in Basic Combustion). Viscosity: Sutherland's law, coefficients per species from Crane (1988, TP-410) and CRC Handbook of Chemistry and Physics (1984). Thermal conductivity: Eucken's relation, k=μ×(Cp+5R/4M) — derived consistently from the viscosity and Cp already established here, per standard transport-phenomena theory. Density: ideal gas law.
Why H2O here uses the same ideal-gas polynomial as N2/O2/CO2/SO2, not the Steam Table module's IAPWS-IF97 engine: IAPWS-IF97 is built for maximum accuracy for pure water/steam near its own saturation line or at high pressure (e.g. inside a boiler drum). In flue gas, H2O is a minor component of an atmospheric-pressure gas mixture, far above its own saturation temperature at that low partial pressure — genuinely close to ideal-gas behavior, where Cp depends on temperature only, not pressure. Using IAPWS-IF97 here would add complexity without a real accuracy gain in this specific context.

Mixture Properties

Per-Species Properties at this Temperature

SpeciesCp (kJ/kg·K)μ (μPa·s)k (W/m·K)

Radiative Properties (CO2, H2O, SO2)

Correlation: rational-polynomial-in-log(pL) fit to modern spectroscopic (HITEMP-based) data — more accurate than classic Hottel charts or Leckner's polynomials, per literature comparisons (Hottel >200% error, Leckner -90%/+180%, this class of correlation ~0.7% average error vs line-by-line reference). Mean Beam Length L=3.5×V/A (Hottel's geometric approximation for an enclosure). CO2 and H2O each use a temperature-dependent branch (<1100K / ≥1100K) selected automatically by the actual flue gas temperature.

Quick reaction — was this calculator useful?

Was this calculator useful? Tell us what's missing or what you'd like to see next.

Send Feedback